background image

Stick the supplied color coded stickers to the batteries 

beside terminals. Wire color should match sticker. 

DO NOT bundle cables in plastic conduit, their cur-

rent rating is only for open air In conduit they may 

overheat. 

TROLLING MOTOR CONNECTION:

1. Remove ALL

ALL

 existing battery cables, SEE WARNING.

SEE WARNING.

2. On a 4 battery system with isolatead starting battery, 

connect the negative of the starting battery to the nega-

tive of battery 11.

3. Connect the BLACK

 BLACK Trollbridge36® ground wire to 

the Negative terminal of battery 11. This terminal also 

connects to the negative of the starting battery and the 

negative side of the trolling motor.

4. The RED

RED

 cable is connected to the positive terminal 

of battery 11. On 3 battery systems this is also the starter 

On 3 battery systems this is also the starter 

motor positive connection.

motor positive connection.

5. The YELLOW

 YELLOW

 cable is the incoming charging line and 

will be connected to the positive of the starting battery. 

When extending use no heavier than 10 gauge up to 10 

feet, 8 gauge over 10 feet. On a 3 battery system connect 

YELLOW

YELLOW

 cable to the RED

RED

 terminal.

6. Connect the PURPLE

PURPLE 

to battery 2 negative.

7. Connect the WHITE

WHITE

 cable to battery 2 positive. 

8. The GREEN

 GREEN

 cable goes to battery 3 negative.  

NO OTHER WIRES CONNECT TO THESE TERMI-

NALS

9. Connect the BLUE

BLUE

 cable to the trolling battery 3 pos-

itive terminal. This is the +36 volt supply to the trolling 

motor

The Trollbridge36® draws no power when not charging 

left connected to the batteries at all times. When “off’ 

there will be 36-volts available to the trolling motor.

OPERATING INSTRUCTIONS:

TROUBLESHOOTING:

Trolling motor must be off to permit charging. 

A volt meter can help diagnose problems. First check the 

voltage across each pair of battery terminals. 

Measure the output voltage (BLACK

BLACK wire to BLUE

BLUE

). If 

it is less than about 30-volts you have a bad battery or a 

wiring problem and to protect the starting battery and 

alternator the Trollbridge36® will NOT

NOT enter charging 

mode.

When charging, measure the voltage on the starting 

battery, the Trollbridge36® green “CHARGING” LED

green “CHARGING” LED

 will 

not come on until the battery gets over 13-volts for 30 

seconds and there is at least 30-volts on the BLUE

BLUE

 wire. 

Check the wiring by putting the negative meter lead on 

the BLACK

BLACK cable. When the LEDs are off you should 

m12-volts on RED

RED

 and PURPLE

PURPLE

, +24-volts on 

WHITE

WHITE

 and GREEN

GREEN

 and +36-volts on BLUE

BLUE

If the green LED

green LED

 is on all battery positive terminals 

should read nearly the same voltage as the starting bat-

tery (13.0 to 14.2 depending on state of charge.). 

The positive terminal of battery 3 will connect to the 

trolling motor positive supply. 6-gauge wire is normal. 

A 50-amp circuit breaker is recommended in this motor 

connection for protection against shorts, motor failure 

and as a safety disconnect. 

The negative side of the trolling motor connects to the 

negative terminal of battery 1 as stated above. 6-gauge 

wire is recommended

DEEP DISCHARGE IS THE BIGGEST BATTERY 

DEEP DISCHARGE IS THE BIGGEST BATTERY 

KILLER.

KILLER.

 Avoid running below 37-volts as much as 

possible.

1. Off

When you start the main engine, or apply any charging 

source to the starting battery, the Trollbridge36® will first 

wait for the starting battery to get some charge (13-volts) 

then automatically put the trolling batteries in parallel 

and deliver charge unless the trolling motor is running 

While charging the GREEN CHARGING LED

GREEN CHARGING LED

 is on and 

only 12-volts will be available to the trolling motor so 

it will not run. If the trolling batteries are low the Troll-

bridge36® may cycle on and off to prevent overloading 

the alternator and preserve the starting battery charge.

2. Charging

When charging stops there will be a delay until the 

battery voltages drop below 13. Before the LED

LED

 goes off 

and 36-volts is available for trolling. Press the REMOTE 

button if you need 36-volts immediately. This will disable 

charging until the charging source (YELLOW

YELLOW

) rests 

below 13-volts.

3. Trolling

Reviews: