YCO-1125-03-13
PPC-300 & PPC-300D Operation Manual
Turning the Scale On and Off
Remove everything from the weighing platform and press the
key to turn the scale on. The display
will briefly flash all segments of the LCD. After approximately five seconds, the display will stop flash
-
ing and automatically set to zero. Press the
key for about three seconds to turn the scale off.
Zero the Scale
If a weight value is displayed when the platform is empty, press the
key to zero the scale while the
weight indication is stable "
". If the weight offset is greater than the push-button zero range, about
56 divisions, then the scale will inidicate "
". If this happens, then turn the scale off and back on
while the platform is empty to return to a zero indication.
Changing Units
To switch between kilogram, pound, ounce and pound-ounce units; press the
and
keys at the
same time.
Checking the Battery Level
The battery status indicator shows the approximate life remaining in the batteries as follows:
2/3 to full charge remaining.
1/3 to 2/3 charge remaining.
Less than 1/3 charge remaining.
Battery charge is too low. Replace all four "D" batteries observing the polarity markings.
Setup Mode Indicator
If the setup mode indicator (
) is visible in normal weighing mode, then the PPC-300 is not configured
to be sealed for legal for trade use. Factory parameter 77 must be set to 003 or 004 for all legal for
trade applications. For instructions on changing the factory parameters, please see section IV Setup in
the PPC-300 Technical Manual.
Basic Weighing
1. Begin with nothing on the weighing platform, the display reading zero,
and the center of zero and stable indicators lit.
2. Place the items to be weighed on the weighing platform and wait for
the stable indication. The weight displayed is the gross weight.
8
IV Using the Scale
Summary of Contents for PPC-300
Page 2: ......
