YCO-1125-03-13
PPC-300 & PPC-300D Operation Manual
Checkweighing Function
This is an example of how the checkweighing function operates once it has been enabled and setup.
The setup for this example has a lower limit of 10.00 lb and an upper limit of 10.25 lb. The scale is set
to flash when a weight within the acceptable weight range is loaded.
Operation
1. The scale should display zero. The
, stable and center-of-zero
indicators should be displayed.
2. If you wish to enter a tare, place the item on the scale platform and
press the
key. The net weight indicator should be displayed, and
the center-of-zero indicator should not.
3. Begin loading the scale with the product to be weighed. As the
amount of product increases, so will the weight display and the length
of the bar chart.
4. The weight reading will begin to flash, and the bar chart will enter the
ACCEPT range when the lower limit weight is reached.
5. The weight reading will continue to flash, and the bar chart will remain
in the ACCEPT range up to, and including, the upper limit weight.
6. If the upper limit weight is exceeded, the weight reading will stop
flashing, and the bar chart will enter the OVER range. Remove
enough product to return to an acceptable weight.
7. When the product weight acceptable, remove the product. To clear
an entered tare, remove everything from the scale platform and press
the
key. Press the
and
keys to toggle between the check-
weighing function and the normal weighing mode.
IV Using the Scale
17
Summary of Contents for PPC-300
Page 2: ......
