28
4.
Operation Method
Program Operation
The example shown below explains the method of program
registration using PrG3.
4.
Register program
①
Select PrG3 referring to 3 mentioned above..
②
Input the number of steps, temperature and time for respective
steps using the program creation sheet.
③
Press the ENTER key. The PA
ｔ１
is displayed with blinking.
("End" is displayed if PrG1 is selected. In this case, go to
⑥
)
④
Select the unused pattern from among Pat1, Pat2 and Pat3 using
the "▲▼".
⑤
Press the ENTER key. "End" is displayed and the step number is
also displayed with blinking.
"End" is a character which indicates the total step number to be
used. "8" will be input here.
⑥
INPUT "8", which is the total step number to be used here, using
the "▲▼".
⑦
Press the ENTER key. The character "SV-1", which indicates the
setting temperature of the first step, is displayed. The current
setting temperature is also displayed with blinking.
⑧
Set the temperature of the first step using the "▲▼".
⑨
Press the ENTER key. The character "t-1", which indicates the
setting time of the first step, is displayed. The current setting time
is also displayed with blinking.
Before setting the time, check the temperature rise/fall capability of
unit. For example, for DP83C, about 120 minutes is needed to
increase the temperature from room temperature to 200
℃
. It takes
about 1 minute to increase the temperature by 1.5
℃
. Add an extra
considering the temperature stability time.
The setting time of timer in respective steps is 999 hours and 50
minutes maximum.
⑩
After the time is set, press the ENTER key.
⑪
The character "SV-2", which indicates the setting temperature of
the second step, is displayed. In the same way, input the
temperature and time for respective steps using the program
creation sheet.
The different method is necessary where program repeat function
is used. In this case, press the SUBMENU key after setting the
time (t-7 in the example) in the step where the repeat operation is
to be used (Step 7 in the example). This enters to the repeat
function setting mode.
Follow the "Use program repeat function" in page 27 for the input
method of program repeating function.
⑫
The screen returns to the initial setting screen after the setting of
temperature and time in the final step is completed.
测 定 温 度
℃
加热器
确定
设定温度
过升防止
停止
开始
定值
故障
自动停止
自动开始
定值运转
程序运转
时间
程序
功能
测 定 温 度
℃
加热器
确定
设定温度
过升防止
停止
开始
定值
故障
自动停止
自动开始
定值运转
程序运转
时间
程序
功能
