10
DP-6100 GP
Technical Manual
1)
Open indicator housing by pulling tab, located on
back of housing, forward.
2)
Remove two Sealing Screws and Board Cover.
3)
Remove wire cover (2 screws) and battery housing
(2 screws) ( see Page 9 Step 10). Battery Housing
is connected by two wires and does not need to be
completely removed, let it hang down out of the way.
4)
The A/D Board is mounted on the right side of the
CPU Board by (2) screws. Remove the (2) screws.
5)
Disconnect the 10-Pin Connector that goes from the
A/D Board into the bottom of the CPU Board.
6)
Disconnect the 7-pin connector that goes from the
A/D Board to the load cell cable. Connector is
located behind original position of battery housing.
7)
A/D Board is now disconnected. Note position of
wires for proper reassembly
8)
Free and remove A/D Board by removing wire holder
and cutting necessary wire ties.
CPU Board
Screw
A/D Board
10-pin
Connector
REPLACING A/D BOARD
Installing new A/D Board:
1)
Installation is reverse of removal.
Note:
Return wires to original position and organize with wire ties. Improper wire positioning will hinder housing
closure.
Important:
If new A/D board is not equipped with filter, then use filter off the old A/D board. Filter is simply an
extension that connects between the 10-pin connector on the A/D board and the 10-pin connector of
the CPU board.
2)
Setup A/D board as shown on page 11.
Sealing
Screws
Board
Cover