![background image](http://html.mh-extra.com/html/yamato/92004/92004_instruction-manual_905351018.webp)
cod.92004 – TDU 210PS
18
•
Use exclusively the type of saw blade that is recommended by the manufacturer and complying that
meets the requirements of EN 847-1.
•
Do not saw any other materials than wood, wood products, aluminium and plastic.
•
Select the correct saw blade for the work piece to be sawn.
•
Connect the dust extraction device before starting the operation.
•
When using the machine in the table saw position, always make sure that the riving knife has been
adjusted properly.
•
When using the machine in the table saw position, always use the push stick to guide the work piece
along the saw blade.
•
When using the machine in the cut-off saw position, check that the upper part of the saw blade is fully
covered by the upper guard.
•
When using the machine in the table saw position, check whether the upper table top is tightened firmly.
•
Always unplug the machine before performing any maintenance.
•
Do not use the machine before it has been completely assembled and installed according to the
instructions.
•
Do not perform any design, assembly or construction activities on the table while the machine is switched
on.
•
Unplug the machine and clean the table before leaving the work area.
Residual risks
The following hazards may occur during the operation of this machine:
•
danger of injury to the fingers and hands while changing the saw blade
•
danger of injury through flying debris from the workpiece
•
danger of hearing damage
•
health risk due to inhalation of airborne particles
DESCRIPTION (fig. A1 & A2)
Your table saw/cut-off saw has been developed for sawing wooden work pieces. The machine is not suitable
for sawing grooves, etc.
1 On/off switch (cut-off saw position)
2 Operating handgrip
3 Lock-off button
4 Lock screw upper table top
5 Dust extraction connection
6 Lock knob bevel angle
7 Scale for bevel angle
8 Head lock down knob
9 Lock knob mitre angle
10 Scale for mitre angle
11Mounting hole
12 Lower table top
13 Guide fence
14 Saw blade guard
15 On/off switch (table saw position)
16 Lower guard
17 Guide fence
18 Upper table top
19 Upper guard
Mounting the machine (fig. A1)
The machine must be screwed to a workbench.
•
Mark the position of the mounting holes (11) on the workbench.
•
Drill holes at each of the marked positions, adjusting the diameter and depth of the holes to the screws
used.
•
Place the machine on the workbench and insert the screws into the mounting holes.
•
Firmly tighten the screws.
Summary of Contents for 92004
