YAMARIN Cross 49 Bow Rider, User Manual

Page: 36 / 42

36 (42)
7.2 Measures before launching the boat
Repair possible damage to the gelcoat surface according to section 6.9.
In coastal areas, antifouling paint should be used to prevent the hull from becoming covered
with vegetation. Fouling of the bottom and, especially, the propeller increases fuel
consumption remarkably. However, if the boat is anchored at the inlet of a stream, in a land-
locked lake, or if it is lifted out of the water at least once every two weeks, it is normally not
necessary to use antifoulin
g paint. Carefully follow the paint manufacturer’s instructions
when applying the paint. When sanding old antifouling paint, remember that the dust is
toxic. Antifouling paint is not necessary in lake areas.
NOTE! Do not apply any paint to the zinc anodes, depth finder sensor, or
the piston rods of the hydraulic trim tabs. Do not apply paints
containing copper or lead on aluminum parts and remember to
follow the paint manufacturer’s instructions. The warranty does
not cover damage caused to the hull by antifouling paint
containing lead or copper.
Useful tip:
Do not throw away a used paint brush. A hardened antifouling
paint brush can be reused if you first soak it for a couple of hours
in a mix of 2 litres of hot water, 100 ml of vinegar, and 50 ml of
baking powder.
Perform the necessary service procedures required for the engine according to the engine
manual. Check the functioning of electric equipment and remove possible oxidation from
fuse connectors etc.
Remember that petrol goes stale over time, and you must always start the engine with fresh
petrol in the spring.
When the boat has been launched you should open all hull bushings and check to ensure
that there are no leaking hoses or connectors. The locations of the through fittings are
presented in Chapter 5. Bring your safety equipment back on board before setting out.