17
18
Ho
w to Use
Ho
w to Use
How to use the device on your skin
<CLEAN, NEB Mode>
Areas you should not treat
Move the electrode head over the skin in the direction of the arrows shown below.
Areas that can only be treated with LED light
(Refer to page 19 for how to use)
* Close your eyes and hold the device
at least 5 cm away from the skin.
Recommended speed for moving the device: 2 cm/second
Left side
One beep
Standby
Approx.
5 minutes
Three short beeps
About
90 seconds
About
90 seconds
Right side
Areas you should not treat: Upper eyelids
<EYE CARE Mode>
Press the electrode head repeatedly on your face from the inner to the outer corners of the eye as if stamping
on the skin (Press
→
Release
→
Move electrode head).
* Be sure not to press down continuously on the skin for longer than 3 seconds.
* Do not move the device while pressing.
If you are concerned about dryness around your eyes,
we recommend applying EYE CARE Mode for approx.
2 minutes for each side (4 minutes in total).
* Lower eyelid and the outer corners of the eye
can be treated.
Estimated pressing time: approx. 3 seconds for each point
Press and move the device in a circular,
massaging motion as indicated by the arrows.
<EMS UP Mode>
Areas that can only be treated with LED light
(Refer to page 19 for how to use)
* Close your eyes and hold the device
at least 5 cm away from the skin.
If you feel an unpleasant tingling on your skin, reduce the intensity level or move to another area.
You could also moisten the skin with water, lotion or gel before using the device.
Failure to comply may cause skin damage.
• Please reapply skin-care products or water during treatment to ensure there is always some liquid between
the electrode head and the skin. If there is an insufficient amount of skin-care products or water, the
stimulation will weaken, causing skin problems.
• If the temperature feels too hot, move the head more quickly. You can also use a cotton pad to lower the
temperature.
• Use the device in a position in which the entire surface of the electrode head comes in contact with your
skin.
• Be sure to move the device over the skin as you use it.
Placing the device continuously on the same area may cause burns or low-temperature injuries.
• Do not put the electrode head on the upper eyelids, lower eyelids or outer corners of the eye.
Left side
One beep
Standby
Approx.
5 minutes
Three short beeps
About
90 seconds
About
90 seconds
Right side
Left side
One beep
Standby
Approx.
5 minutes
Three short beeps
Approx.
1 minutes
Approx.
1 minutes
Right side