–10–
E Fasten the wireharness pickup coil lead handlebar
switch lead (left and right) main switch lead TPS
lead with a band.
F To the carburetor.
G Insert the projection of the band to the hole of the
frame and fasten the wireharness, neutral switch
lead handlebar switch leads (left and right), main
switch lead, TPS lead, rear brake switch lead and
pickup coil lead with them.
H Neutral switch lead can be put either over or under
the wireharness and starter motor.
I Route the starter motor lead under the wireharness
and battery negative (–) lead.
J Fasten the starter motor lead to the rear fender with
a band.
K Fasten the battery positive (+) lead and starter mo-
tor lead with a band.
CABLE ROUTING
SPEC
L Position the rear turn signal light connectors (left
and right) and taillight connector between the rear
fender and taillight bracket.
M Install the seatlock cable to the frame bracket with
protector side.
N Fasten the lead through under the wireharness and
oil relay lead.
O Fasten the alarm leads wireharness oil relay lead
and ground lead with a band.
P Fasten the starter relay lead and battery negative
(–) lead to the wireharness with a band. Don’t put
the upper end of the band between the seat rail and
the seat bottom.
Q From the engine.
R To the fuel filter.
S Fasten the battery negative (–) lead and wirehar-
ness with a band.
