National Cycle, Inc.
PO Box 158 Maywood, IL 60153-0158 USA
708-343-0400 / Fax 708-343-0625 / www.nationalcycle.com / [email protected]
©2020 National Cycle, Inc.
Page 1 of 2
10-110082-000 03/20
Thank you for purchasing a National Cycle product. Read these instructions carefully and thoroughly before beginning work. Dealers, if installing this
windshield for a customer, please give them this manual upon completion. It contains information needed to properly maintain and use this product.
Quantum® Hardcoated Polycarbonate
Custom Replacement Screens for:
2014-Current FLHT/FLHX Models
N27410 Fly Boy™ Windscreen; Dark Tint
N27420 Bad Boy™ Windscreen; Dark Tint
N27430 Gee Bee™ Windscreen; Dark Tint
CONTENTS OF KIT
ITEM DESCRIPTION QTY.
(1)
Custom Windscreen 1
TOOLS REQUIRED
T-27 Torx Wrench
ALL OEM FASTENERS
WILL BE REUSED.
PREPARATION
1. Place motorcycle securely on its sidestand.
2. Protect the fender and fairing from damage that may be
caused by dropped hardware or tools.
INSTALLATION
1. Using a T-27 Torx wrench, loosen and remove the two outside
OEM windscreen screws (B). Then loosen – but do not
remove – the center OEM windscreen screw (A).
2. Remove the OEM windscreen by gently pulling it forward and
then straight up.
3. Install your new Custom WIndscreen (1) in the reverse order.
4. Now securely tighten – but not over-tighten – all three screws.
Make sure the two outside screws (B) are correctly thread-
ed and not crossthreaded into the OEM retaining Wellnuts.
That’s all there is to it. Enjoy the ride!
