PERIODIC MAINTENANCE AND ADJUSTMENT
7
-3
3
7
6. Pull the wheel axle out, remove
the speed sensor by pulling it out,
and then remove the wheel.
NO-
TICE:
Do not apply the brake
after the brake calipers have
been removed, otherwise the
brake pads will be forced shut.
[ECA11051]
EAUE0400
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Install the speed sensor at the
wheel hub.
TIP
Make sure that the projections on the
speed sensor rotor are aligned with
the notches in the wheel hub and that
the slot in the speed sensor fits over
the retainer on the fork leg.
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground.
5. Push down hard on the handlebar
several times to check for proper
fork operation.
6. Install the brake caliper by install-
ing the bolts.
TIP
Make sure that there is enough space
between the brake pads before install-
ing the brake caliper onto the brake
disc.
7. Install the brake hose holder by
installing the bolt.
8. Install the speed sensor lead
holder by installing the bolt.
9. Tighten the wheel axle and brake
caliper bolts to the specified
torques.
1. Speed sensor
Tightening torques:
Wheel axle:
60 Nm (6.0 m·kgf, 44 ft·lbf)
Brake caliper bolt:
35 Nm (3.5 m·kgf, 25 ft·lbf)
54CF8199E1.book Page 34 Thursday, April 1, 2010 1:24 PM
