2-44
T Fasten the EXUP servo motor
lead with the clamp inserted to
the frame.
U Fasten the wire harness with the
clamp inserted to the hole of bat-
tery box. Point the tip of clamp
upward. Cut the tip according to
the illustration.
V Fasten the EXUP servo motor
lead with the clamp inserted to
the frame.
W Clamp the oil level gauge and
sidestand switch lead.
X AI system hose (Route by the
most inner side.)
CABLE ROUTING
SPEC
N Point the tip of the band to the in-
ner side.
O Routing position of each hose
except the AI system hose is not
regulated in the clamp.
P Pass all the hoses under the in-
jector sub lead and wire harness.
Q Neutral switch lead:
Route the lead so that it surely
points to the right upward.
R Clamp the lead making slack so
that the harness routes to the
coupler from the downside of the
EXUP serve motor.
S Pay attention to the inserting
direction of the relay.
Y Position the clamp between the
clamp of oil level switch lead and
the radiator coolant hose. The
direction of clamp is not regu-
lated.
Z Route the hoses of fuel tank
drain and breather underneath
the wire harness, injector sub
lead, AI system lead and AC
magneto lead.
AA To wiring section
.
AB To wiring sections
,
.
AC To wiring section
.
AD Fasten the EXUP servo motor
lead and rear brake switch
lead with the clamp inserted to
the frame.
2
2
3
3
35
