2-40
CABLE ROUTING
SPEC
1
Turn signal light lead
2
Radiator hose
3
Reservoir tank breather hose
(L = 440)
4
Clutch cable
5
Crankshaft position sensor lead
6
Rear brake switch lead
7
Wiring section
8
Coolant breather hose
9
Clutch cable
10
Handlebar switch lead
11
Main switch lead
12
Assembling point
13
Cover steering
14
Assembling point
15
Wiring section
3
3
4
1
A Route the clutch cable through
the backward of radiator bracket
and inside of coolant breather
hose.
B To cord headlight.
C To turn signal light.
D Point the open side to the vehicle
outside.
E Fasten the clutch cable with the
clamp to the inside of the coolant
reservoir tank.
F Fasten the sidestand switch lead
behind the bracket and cut the
tip.
G To fuel tank.
H Pass the throttle cable in front of
the brake hose.
I Pass the clutch cable behind the
front fork.
J Pass the handlebar switch lead
and main switch lead between
the steering stopper and front
fork outer tube.
K Pass the throttle cable, handle-
bar switch lead between the un-
der bracket and the cover
steeirng. There should be no
twist and crossing of the cable.
L In this area, the handlebar switch
lead (right side) should not be in
front of the throttle cable. It
should not cross the throttle
cable around the guide-air.
31
