For Service Engineers
Service Information
SI1906002E-001=YSP10 installation and adjustment procedures
41/120
Check the fitting of the line alignment jigs.
Refer to “1.2 Line alignment jig arrangement” through “1.2.3 How to use the offset line alignment jig set”
on page 5 through 7 for how to use line alignment jigs.
Item
Specification
Conveyor to conveyor
connection
No height difference or offsets that hinder
smooth board transfer
Distance between machines
Distance between upstream/downstream
machine: 7 +/- 3mm
Note
When the lock nut is fastened at “9.4 Fasten the levelling bolts” below, the machine height will be
raised by the amount of leveling bolt backlash (approx. 0.5mm). In consideration of this, the line
alignment is to be adjusted.
Note
The desirable difference between the board transfer height is 0 through 0.1mm higher from
downstream machine.
View from directly above
View from the side