AUTO SETUP
30
5
Press
/
to select BEAM OPT+SOUND
OPTIMZ, BEAM OPTIMZ only or SOUND
OPTIMZ only and then press ENTER.
The following screen appears on your TV.
BEAM OPT+SOUND OPTIMZ
(Beam optimization and YPAO sound
optimization)
Use to optimize the beam angle, delay, volume and quality
so that the parameters best match your listening
environment.
It is recommended that you should select this optimization
feature in the following cases:
• If you make settings for the first time.
• If the unit has been relocated.
• If your listening room has been restructured.
• If the objects in your listening room (furniture, etc.)
have been rearranged.
BEAM OPTIMZ only
(Beam optimization only)
Use to optimize the beam angle so that the parameter best
matches your listening environment.
SOUND OPTIMZ only
(YPAO sound optimization only)
Use to optimize the beam delay, volume and quality so
that the parameters best match your listening environment.
It is recommended that you should select this optimization
feature in the following cases:
• If you have opened or closed the curtains in your
listening room before using this unit.
• If you have manually set the beam angle.
You must optimize the beam angle in the BEAM OPTIMZ only
procedure before starting the SOUND OPTIMZ only procedure.
6
Press
/
/ / to select and configure
each parameter and then press ENTER.
INSTALLING (Installing)
Use to select the installed position of the unit in your
listening room.
Choices:
Parallel to Wall
(Parallel with wall
installation),
Angle to Wall or corner (Corner installation)
• Select Angle to Wall or corner if the unit is installed in
the corner. The beam mode is set to ST+3BEAM (see
page 41).
• Select Parallel to Wall if the unit is installed in parallel
with the wall. The beam mode is set to 5BEAM (see
page 41).
Note
ENTER
ENTER
.
INSTALLING
;;
Parallel to Wall
MOUNTING
;;;;
SHELF
REFLECTING
;;
NORMAL
Set MIC in front of YSP
MIN 2m/6.5ft
[]/[]:Up/Down/[ ]/[ ]:Sel
[ENTER]:Start
p
p
PREPARATION
p
p
ENTER
Angle to Wall or corner
Parallel to Wall
