AUTO SETUP
29
SETUP
English
• If your listening room has curtains, open the curtains before
starting the BEAM OPT+SOUND OPTIMZ or the BEAM
OPTIMZ only procedure.
• Make sure that your listening room is as quiet as possible while
this unit is performing the AUTO SETUP procedure.
• Once the AUTO SETUP procedure has started, position
yourself beside or behind this unit so that you may not obstruct
the path of sound beams. To achieve the best results possible,
however, it is strongly recommended that you should evacuate
yourself from your listening room until the AUTO SETUP
procedure is completed.
• Be advised that it is normal for loud test tones to be output
during the AUTO SETUP procedure.
• The AUTO SETUP procedure may not be run successfully if
this unit is installed in one of the rooms described in “Before
installing this unit” on page 11. In such cases, run BASIC
SETUP (see page 57) or MANUAL SETUP (see page 63) to
manually adjust the corresponding parameters.
• If the AUTO SETUP procedure stops and an error message
appears on the screen, see “Error messages for AUTO SETUP”
on page 33 for appropriate remedies.
y
You can save the settings optimized by the AUTO SETUP
procedure (see page 34). A set of settings optimized according to
specific conditions of your listening environment can be recalled
later depending on the varying conditions of your listening
environment (see page 35).
1
Press STANDBY/ON on the front panel or on
the remote control to turn on the power of
this unit.
2
Press YSP on the remote control to switch to
the operation mode of this unit.
3
Press MENU on the remote control.
The SET MENU screen appears on your TV.
y
• The control buttons used for SET MENU are displayed on
the bottom of the screen.
• To return to the previous screen while using SET MENU,
press RETURN on the remote control.
• To resume cursor button operations after changing the
control area by pressing an input selector button, press
TEST on the remote control.
• To cancel the SET MENU screen, press MENU once
more.
• You can also perform the following operations in the front
panel display.
• If you press an input selector button during the SET
MENU operations, the cursor buttons become ineffective.
In this case, press TEST once.
4
Press
/
on the remote control to select
AUTO SETUP and then press ENTER.
The following screen appears on your TV.
Notes
STANDBY/ON
or
Front panel
Remote control
YSP
MENU
.
;
MEMORY
;
AUTO SETUP
;
BASIC SETUP
;
MANUAL SETUP
[]/[]:Up/Down
[ENTER]:Enter
p
p
SET MENU
.
BEAM+SOUND OPTIMZ
BEAM OPTIMZ only
SOUND OPTIMZ only
[]/[]:Up/Down
[ENTER]:Enter
p
p
;
AUTO SETUP
ENTER
ENTER
