4
En
4 Adjust the angle of your iPod or iPhone
so that it is aligned parallel to PDX-50TX.
5 To charge the iPod or iPhone, place it on
PDX-50BC.
■
Group selection switch
Use this switch to set the group ID. To establish a
wireless connection (AirWired) with another
Yamaha product, set both the products to the same
group.
y
•
PDX-50TX supports “1” (A1), “2” (A2), and “3”
(A3) on some Yamaha products that support
“AirWired”.
■
Disconnecting the iPod or
iPhone
To disconnect the iPod or iPhone from PDX-50TX
(transmitter), pull the iPod or iPhone upward.
y
•
Disconnection may be difficult under low
temperature. In this case, do not disconnect the
iPod or iPhone by force; loosen off the tab on the
back of PDX-50TX to make the disconnection
easier.
LED
Status
Off
An iPod or iPhone is not
connected, or has stopped
playing. However, lights up
for 30 seconds or 2 minutes
(depends on the iPod/iPhone)
after connecting or stopping
playback.
Flashes green
continuously
Connection in progress,
please wait.
Flashes green
once
Adjusting the volume level.
Lights up
green
A connection is established.
You are ready to start
playback of iPod on another
Yamaha product.
Lights up
green and
flashes red
Flashes red for 2 seconds: An
unsupported iPhone or iPod is
connected.
Keeps flashing red:
Connection failed.
Flashes red
(regardless of
green status)
The battery of the iPod or
iPhone is low.
Group selection switch
Match the group
selection switch with
the group ID to set.
