Yamaha YFM45FAT, Supplementary Service Manual

Page: 56 / 73

– 48 –
DRIV
REAR CONSTANT VELOCITY JOINTS, FINAL DRIVE
GEAR AND DRIVE SHAFT
3. Install:
• universal joint yoke
• washer
• nut
1
NOTE:
Use the universal joint holder
2
to hold the
yoke.
4. Install:
• drive shaft assembly
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Install the opposite yoke into the U-joint.
b. Apply wheel bearing grease to the bearings.
c. Install the bearings
1
onto the yoke.
CAUTION:
Check each bearing. The needles can eas-
ily fall out of their races. Slide the yoke
back and forth on the bearings; the yoke
will not go all the way onto a bearing if a
needle is out of place.
d. Press the bearings into the U-joint using a
suitable socket.
NOTE:
The bearing must be inserted far enough into
the U-joint so that the circlip can be installed.
e. Install the circlips
2
into the groove of each
bearing.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
Universal joint holder
P/N. YM-04062, 90890-04062
1
2
T
R
.
.
97 Nm (9.7 m · kg, 70 ft · lb)