INSTRUMENT AND CONTROL FUNCTIONS
4-8
4
automatically, and the display will re-
turn to the prior mode after refueling
and traveling 5 km (3 mi).
To set the clock
1. Push the “
” or “
” side of the
“SELECT” switch to change the
display to the clock mode.
2. Push the “
” side of the “SE-
LECT” switch and the “RESET”
switch together for at least two
seconds.
3. When the hour digits start flash-
ing, push the “
” or “
” side of
the “SELECT” switch to set the
hours.
4. Push the “RESET” switch, and the
minute digits will start flashing.
5. Push the “
” or “
” side of the
“SELECT” switch to set the min-
utes.
6. Push the “RESET” switch and
then release it to start the clock.
Self-
d
ia
g
nosis
d
evice
This model is equipped with a self-di-
agnosis device for various electrical
circuits.
If a problem is detected in any of those
circuits, the engine trouble warning
light will come on and the odome-
ter/tripmeter/clock display will indicate
an error code.
If the odometer/tripmeter/clock display
indicates any error codes, note the
code number, and then have a
Yamaha dealer check the vehicle.
The self-diagnosis device also detects
problems in the immobilizer system
circuits.
If a problem is detected in the immobi-
lizer system circuits, the immobilizer
system indicator light will flash and the
display will indicate an error code.
TIP
If the display indicates error code 52,
this could be caused by transponder
interference. If this error code appears,
try the following.
1. Use the code re-registering key to
start the engine.
TIP
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
1. Clock
1. Error code display
2. Engine trouble warning light “
”
3. Immobilizer system indicator light
1
2
3
U12C28E0.book Page 8 Wednesday, July 2, 2014 3:29 PM
