INSTRUMENT AND CONTROL FUNCTIONS
3-18
3
6. Install the mudguard and ignitor
unit panel by installing the quick
fasteners.
NOTE:
To install a quick fastener, push the pin
back so that it will protrude from the fas-
tener head, and then insert the fastener
and push the protruding pin in until it is
flush with the fastener head.
7. Install the rider seat.
WARNING
EWA10220
This shock absorber contains highly
pressurized nitrogen gas. For prop-
er handling, read and understand
the following information before
handling the shock absorber. The
manufacturer cannot be held re-
sponsible for property damage or
personal injury that may result from
improper handling.
●
Do not tamper with or attempt to
open the gas cylinder.
●
Do not subject the shock ab-
sorber to an open flame or other
high heat sources, otherwise it
may explode due to excessive
gas pressure.
●
Do not deform or damage the
gas cylinder in any way, as this
will result in poor damping per-
formance.
●
Always have a Yamaha dealer
service the shock absorber.
Spring preload setting:
Minimum (soft):
1
Standard:
XVS1100 3
XVS1100A 4
Maximum (hard):
XVS1100 7
XVS1100A 9
1. Quick fastener (after removal)
2. Quick fastener (before installation)
U3B820E0.book Page 18 Tuesday, April 12, 2005 9:43 AM
