PERIODIC MAINTENANCE AND ADJUSTMENT
7-13
7
NOTICE
ECA10900
Make sure that the oil filler cap is se-
curely tightened, otherwise oil may
seep out when the engine is run-
ning.
To change the engine oil (with or
without oil filter cartridge replace-
ment)
1. Remove the rider seat. (See page
2. Start the engine, warm it up for
several minutes, and then turn it
off.
3. Place an oil pan under the oil tank
to collect the used oil.
4. Remove the engine oil filler cap,
the drain bolt and its gasket to
drain the oil from the oil tank.
5. Place an oil pan under the engine
to collect the used oil.
6. Remove the engine oil drain bolt
and its gasket to drain the oil from
the crankcase.
TIP
Skip steps 7–9 if the oil filter cartridge is
not being replaced.
7. Remove the oil filter cartridge with
an oil filter wrench.
TIP
An oil filter wrench is available at a
Yamaha dealer.
8. Apply a thin coat of clean engine
oil to the O-ring of the new oil filter
cartridge.
1. Engine oil drain bolt (oil tank)
2. Gasket
1. Engine oil drain bolt (crankcase)
2. Gasket
2
1
1
1
1
2
2
2
1. Oil filter cartridge
2. Oil filter wrench
U1BH10E0.book Page 13 Tuesday, December 8, 2009 4:47 PM
