Perio
d
ic maintenance an
d
a
d
justment
7-11
7
through the engine oil level check
window located at the bottom-
right side of the crankcase.
TIP
The engine oil should be between the
minimum and maximum level marks.
4. If the engine oil is at or below the
minimum level mark, remove the
oil filler cap and add oil.
5. Check the engine oil filler cap O-
ring. Replace if damaged.
6. Install the engine oil filler cap.
To chan
g
e the en
g
ine oil (an
d
filter)
1. Start the engine and allow it to idle
for a few minutes to warm up the
oil, and then stop the engine.
2. Place an oil pan under the oil tank
to collect the used oil.
3. Remove the engine oil filler cap,
the drain bolt and its gasket to
drain the oil from the oil tank.
4. Place an oil pan under the engine
to collect the used oil.
5. Remove the engine oil drain bolt
and its gasket to drain the oil from
the crankcase.
TIP
Skip steps 6–10 if the oil filter cartridge
is not being replaced.
1. Engine oil level check window
2. Maximum level mark
3. Minimum level mark
4. Engine oil filler cap
1. Engine oil filler cap
2. O-ring
4
2
3
1
2
1
1. Engine oil drain bolt (oil tank)
2. Gasket
1. Engine oil drain bolt (crankcase)
2. Gasket
1
2
1
2
UBP914E0.book Page 11 Wednesday, October 6, 2021 4:52 PM
