– 61 –
FI
Fault code No.
16
Symptom
The throttle position sensor is detected stuck.
Used diagnostic code No. 01 (throttle position sensor)
Order
Item/components
Check or maintenance job
Restore method
1
Defective throttle position sensor
Replace the sensor if it is defective.
Refer to “THROTTLE BODY ASSEMBLY” in
chapter 7. (Manual No.: 5VK1-AE1)
Reinstated by start-
ing the engine, oper-
ating it at idle, and
then racing it.
2
Throttle position sensor installation
Execute the diagnostic mode. (Code No. 01)
Check the sensor for looseness or pinching.
Check that the sensor is installed in the specified
position. Refer to “THROTTLE BODY ASSEM-
BLY” in chapter 7. (Manual No.: 5VK1-AE1)
Fault code No.
19
Symptom
Open circuit is detected in the input wire from the sidestand switch to the ECU.
Used diagnostic code No. 20 (sidestand switch)
Order
Item/components
Check or maintenance job
Restore method
1
Coupler connections
ECU coupler
Blue/Black connector
Check the couplers for any pins that may have
pulled out.
Check that the couplers are securely locked.
If necessary, repair the coupler or securely con-
nect it.
If the transmission is
in gear, it is rein-
stated by retracting
the sidestand.
If the transmission is
in neutral, it is rein-
stated by reconnect-
ing the wiring.
2
Open or short circuit in the wire har-
ness
Repair or replace if there is an open or short cir-
cuit between the ECU and sidestand switch.
Blue/Black
3
Defective sidestand switch
Execute the diagnostic mode. (Code No. 20)
Replace the switch if it is defective.
Refer to “CHECKING THE SWITCHES” in chap-
ter 8. (Manual No.: 5VK1-AE1)
Fault code No.
21
Symptom
Open or short circuit is detected from the coolant temperature sensor.
Used diagnostic code No. 06 (coolant temperature sensor)
Order
Item/components
Check or maintenance job
Restore method
1
Coolant temperature sensor instal-
lation
Check the sensor for looseness or pinching.
Reinstated by set-
ting the main switch
to “ON’.
2
Coupler connections
Coolant temperature sensor cou-
pler
ECU coupler
Check the coupler for any pins that may have
pulled out.
Check that the couplers are securely locked.
If necessary, repair the coupler or securely con-
nect it.
3
Open or short circuit in the wire har-
ness
Repair or replace if there is an open or short cir-
cuit between the wire harnesses.
Black/Blue - Black/Blue
Green/Red - Green/Red
4
Defective coolant temperature sen-
sor
Execute the diagnostic mode. (Code No. 06)
Replace the sensor if it is defective.
Refer to “COOLING SYSTEM” in chapter 8.
(Manual No.: 5VK1-AE1)
