Operation an
d
important ri
d
in
g
points
6-1
6
EAU15952
Read the Owner’s Manual carefully to
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
EWA10272
Failure to familiarize yourself with
the controls can lea
d
to loss of con-
trol, which coul
d
cause an acci
d
ent
or injury.
EAUM3632
TIP
This model is equipped with:
z
a lean angle sensor. This sensor
stops the engine in case of a vehi-
cle turnover. If this happens, the
engine trouble warning light will
come on, but this is not a malfunc-
tion. Turn the vehicle power off
and then back on again to cancel
the warning light. Failing to do so
will prevent the engine from start-
ing even though the engine will
crank when pushing the start
switch.
z
an engine auto-stop system. The
engine stops automatically if left
idling for 20 minutes. If the engine
stops, simply push the start
switch to restart the engine.
EAU73430
Startin
g
the en
g
ine
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
z
The transmission is in the neutral
position.
z
The transmission is in gear with
the clutch lever pulled and the
sidestand up.
See page 4-27 for more informa-
tion.
1. Turn the key to “ON” and make
sure that the start/engine stop
switch is set to “
”.
The following warning lights and
indicator light should come on for
a few seconds, then go off.
z
Oil level warning light
z
Coolant temperature warning
light
z
Engine trouble warning light
z
Immobilizer system indicator
light
NOTICE
ECA17671
If the a
b
ove warnin
g
li
g
hts or in
d
ica-
tor li
g
ht
d
o not come on initially
when the key is turne
d
to “ON”, or if
UBAEE0E0.book Page 1 Tuesday, December 10, 2019 2:42 PM