PERIODIC MAINTENANCE AND ADJUSTMENT
7-37
2
3
4
5
6
7
8
9
installing the spacers, be sure
to install them on the correct
side.
[ECA17700]
2. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before install-
ing the brake caliper onto the brake
disc.
3. Insert the wheel axle from the
right-hand side.
4. Install the axle nut.
5. Lower the front wheel so that it is
on the ground, and then put the
sidestand down.
6. Tighten the axle nut, and then the
front wheel axle pinch bolts to the
specified torques.
7. Push down hard on the handlebar
several times to check for proper
fork operation.
EAU25080
Rear wheel
EAU45183
To remove the rear wheel
WARNING
EWA10821
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
2. Lift the rear wheel off the ground
according to the procedure on
page 7-35.
3. Remove the axle nut and washer.
4. Loosen the locknut on each side of
the swingarm.
5. Turn the drive chain slack adjust-
ing bolts fully in direction (a).
6. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
Tightening torques:
Axle nut:
90 Nm (9.0 m·kgf, 65 ft·lbf)
Front wheel axle pinch bolt:
12 Nm (1.2 m·kgf, 8.7 ft·lbf)
1. Axle nut
2. Washer
1
2
1. Drive chain slack adjusting bolt
2. Locknut
3. Brake caliper
1
2
3
(a)
1DX-9-20.book 37 ページ ２０１１年１０月１２日 水曜日 午前９時３９分
