PERIODIC MAINTENANCE AND ADJUSTMENT
6-10
1
2
3
4
5
6
7
8
9
10
11
12
engine oil filler cap.
8. Install the engine oil check bolt and
gasket, and then tighten the bolt to
the specified torque.
9. Start the engine and warm it up for
a few minutes. Then turn the en-
gine off and wait a few minutes to
allow the oil to settle. Use the en-
gine oil tank cap and dipstick to
confirm that the engine oil level is
correct.
To change the engine oil (with or
without oil filter element replace-
ment)
1. Place the vehicle on a level sur-
face.
2. Start the engine, warm it up for
several minutes, and then turn it
off.
3. Place an oil pan under the engine
to collect the used oil.
4. Remove the engine guard by re-
moving the bolts.
5. Remove the engine oil tank cap
and the engine oil filler cap.
6. Remove the engine oil drain bolts
and their gasket to drain the oil
from the oil tank and crankcase.
7. Remove the engine oil filter ele-
ment drain bolt and its gasket to
drain the oil from the oil filter ele-
Tightening torque:
Engine oil check bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1. Bolt
2. Engine guard
1. Engine oil tank cap
2. Engine oil filler cap
2
1
1
1
2
1. Engine oil drain bolt (oil tank)
2. Gasket
1. Engine oil drain bolt (crankcase)
2. Gasket
2
1
2
1
1DX-9-E3.book 10 ページ ２０１４年２月１７日 月曜日 午後２時２１分
