Maintenance
41
Engine oil tank capacity:
1.2 L (1.27 US qt) (1.06 Imp.qt)
Remote oil tank capacity:
10.5 L (11.10 US qt) (9.24 Imp.qt)
Recommended gear oil:
Hypoid gear oil SAE#90
Gear oil quantity:
1050.0 cm
3
(35.50 US oz)
(37.03 Imp.oz)
Tightening torque for engine:
Spark plug:
25.0 Nm (18.4 ft-lb) (2.55 kgf-m)
Propeller nut:
55.0 Nm (40.6 ft-lb) (5.61 kgf-m)
EMU28222
Transporting and storing
outboard motor
WARNING
EWM00690
●
Leaking fuel is a fire hazard. When
transporting and storing the outboard
motor, close the air vent screw and fuel
cock to prevent fuel from leaking.
●
USE CARE when transporting fuel tank,
whether in a boat or car.
●
DO NOT fill fuel container to maximum
capacity. Gasoline will expand consid-
erably as it warms up and can build up
pressure in the fuel container. This can
cause fuel leakage and a potential fire
hazard.
WARNING
EWM00700
Never get under the lower unit while it is
tilted, even if a motor support bar is used.
Severe injury could occur if the outboard
motor accidentally falls.
CAUTION:
ECM00660
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be trail-
ered in the normal running position, use
an additional support device to secure it
in the tilt position.
The outboard motor should be trailered and
stored in the normal running position. If there
is insufficient road clearance in this position,
then trailer the outboard motor in the tilt po-
sition using a motor support device such as
a transom saver bar. Consult your Yamaha
dealer for further details.
EMU30250
Storing outboard motor
When storing your Yamaha outboard motor
for prolonged periods of time (2 months or
longer), several important procedures must
be performed to prevent excessive damage.
This is especially important for your oil injec-
tion equipped outboard motor due to the lean
oil ratios used at idle prior to shutting the en-
gine off for the season. It is advisable to have
your outboard motor serviced by an autho-
rized Yamaha dealer prior to storage. How-
ever, you, the owner, with a minimum of
tools, can perform the following procedures.
CAUTION:
ECM01390
Do not use any chemical goods contain-
ing Silicon, Phosphorus, or Lead. Con-
sult your Yamaha dealer for details on the
use of chemical goods for storage.
EMU28301
Procedure
EMU30230
Flushing with the flushing device
1.
Wash the outboard motor body using
fresh water. For further information, see
page 44.
2.
Fill the fuel tank with fresh fuel and add
©
2019 Yamaha Motor Corporation, U.S.A.
Summary of Contents for VZ200 2019
Page 64: ...Maintenance 59 ZMU01943 2 0 1 9 Y a m a h a M o t o r C o r p o r a t i o n U S A...
Page 73: ...Consumer information 68 2 0 1 9 Y a m a h a M o t o r C o r p o r a t i o n U S A...
Page 75: ...Consumer information 70 2 0 1 9 Y a m a h a M o t o r C o r p o r a t i o n U S A...
Page 76: ...Consumer information 71 2 0 1 9 Y a m a h a M o t o r C o r p o r a t i o n U S A...
