Yamaha VXS10S, Owner'S Manual

Page: 4 / 9

To detach the mounting bracket from the bracket base, release the
lock of the mounting bracket with a long flat-blade driver and lift the
speaker.
CAUTION
Be sure to perform this work with two or more people.
7
Plug the Euroblock connectors into the
SATELLITE SPEAKERS and INPUT sockets.
To determine the appropriate size of the UB-DXR8, download the “U
BRACKET OWNER’S MANUAL” from the following manual library site.
http://www.yamaha.co.jp/manual/
1
Assemble two L-shaped brackets into a U-shape using the M5 × 10
screws included with the UB-DXR8 as shown below. Peel off the
sheet from each rubber spacer (14 mm thickness; included with the
speaker), and attach the spacers to the inside of each bracket arm
aligning the holes so that the hexagon bolts can be inserted.
Affix the rubber spacers firmly when you attach them.
2
Make sure that the width of the U bracket matches the speaker width.
3
Affix the U bracket on the ceiling using appropriate mounting
hardware.
4
Use the hexagon bolts, spring washers and flat washers included
with the speaker to attach the speaker to the UB-DXR8.
CAUTION
Be sure to perform this work with two or more people.
Installing on the ceiling (using the optional UB-DXR8)
M5 × 10
Rubber spacer
Hexagon bolt
Spring washer
Flat washer
5
Plug the Euroblock connectors into the
SATELLITE SPEAKERS and INPUT sockets.
This section explains how to attach the included safety wire.
CAUTION
• Make sure to take measures to prevent the speaker from falling down in
the event of a installation failure.
• When installing the safety wire to the wall, install it higher than the wire’s
attachment point on the speaker, with as little slack as possible.
• If the safety wire is too short, prepare another wire appropriate for the
speaker weight and installation conditions. If the wire is too long, should
the speaker fall, the wire may snap as a result of too much strain.
1
Pass the safety wire through the eyebolt on the rear of the speaker.
2
Pass the bracket of the safety wire through the loop on the other end,
and pull tight up against the eyebolt.
3
Affix the bracket of the safety wire to the wall.
3
ATTACH THE SAFETY WIRE
Eyebolt