
PERIODIC MAINTENANCE AND MINOR REPAIR
Front brake
1. Minimum level mark
1. Minimum level mark
EAU03418
Checking the brake fluid level
Insufficient brake fluid may allow air to
enter the brake or clutch systems, pos-
sibly causing them to become ineffec-
tive.
Before riding, check that the brake fluid
is above the minimum level mark and
replenish if necessary. A low brake flu-
id level may indicate worn brake pads
and/or brake system leakage. If the
brake level is low, be sure to check the
brake pads for wear and the brake sys-
tem for leakage.
N O T E :
To check the rear brake fluid level, re-
move panel B. (See page 6-9 for panel
removal and installation procedures.)
Observe these precautions:
l
When checking the fluid level,
make sure that the top of the mas-
ter cylinder is level by turning the
handlebars.
l
Use only the recommended quali-
ty brake fluid, otherwise the rubber
seals may deteriorate, causing
leakage and poor braking or clutch
performance.
Clutch
Recommended brake fluid: DOT 4
6 - 2 9
1 . P a n e l B
2. Minimum level mark
l
Refill with the same type of brake
fluid. Mixing fluids may result in a
harmful chemical reaction and
lead to poor braking or clutch per-
formance.
l
The diaphragm will lose its shape
from the negative pressure if the
brake fluid level goes down too far.
Be sure to put the diaphragm back
in its original shape before install-
ing it into the master cylinder.
l
Be careful that water does not en-
ter the master cylinder when refill-
ing. Water will significantly lower
the boiling point of the fluid and
may result in vapor lock.
Summary of Contents for Vmax VMX12N
Page 1: ......
Page 10: ......
Page 27: ...INSTRUMENT AND CONTROL FUNCTIONS Damping force Minimum soft 1 Standard 1 Maximum hard 4 3 14 ...