Yamaha VINO XC50Z, Owner'S Manual

Page: 45 / 84

6-45
1
2
3
4
5
6
7
8
9
EAU1722A
PERIODIC MAINTENANCE AND ADJUSTMENT
6-9
1
2 3 4
1
ZAUM00**
1. Engine oil drain bolt B
2. O-ring
3. Compression spring
4. Strainer
4. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the oil strainer, compression
spring, O-ring and engine oil drain
bolt B.
TIP
Make sure that the O-ring is properly
seated.
7. Install engine oil drain bolt A, and
then tighten both drain bolts to their
specified torques.
Tightening torque:
Engine oil drain bolt A:
23 Nm (2.3 m • kgf, 16.6 ft • lbf)
Engine oil drain bolt B:
32 Nm (3.2 m • kgf, 23.1 ft • lbf)
1
ZAUM00**
1. Oil filler hole
8. Refill with the specified amount of
the recommended engine oil, and
then install and tighten the oil filler
cap.
Recommended engine oil:
See page 8-1.
Oil change quantity:
0.78 L (0.82 US qt, 0.69 Imp.qt)
ECA11670
NOTICE
● ● ● ● ● Do not use oils with a diesel
specification of “CD” or oils of a
higher quality than specified. In
addition, do not use oils labeled
“ENERGY CONSERVING II” or
higher.
● ● ● ● ● Be sure no foreign material en-
ters the crankcase.
9. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking,
immediately turn the engine off and
check for the cause.
10. Turn the engine off, and then check
the oil level and correct it if neces-
sary.