Yamaha Venture XVZ13TFMW, Owner'S Manual

Page: 44 / 124

AUDIO SYSTEM AND CB RADIO
4-6
4
EAU15502
Making mode settings
General procedure
The following setting procedure applies
to the audio system, CB radio, and op-
tional CD changer.
NOTE:
● In order to make settings in any of
the audio system modes, make
sure that the audio system is se-
lected. If necessary, push the “AU-
DIO” button for less than one
second.
●
In order to make settings in the CB
radio modes, make sure that the
CB radio is selected. If necessary,
push the “CB” button for less than
one second.
1. Repeatedly push the “SELECT”
button for less than one second
until the desired mode appears in
the display. With each press of the
button, the mode changes in the
following sequence.
Audio system
CB Radio
2. While the selected mode is dis-
played (for about five seconds), re-
peatedly push either side of the
up/down switch for less than one
second until the desired setting is
displayed.
Selecting the output (speakers or
headsets)
1. Repeatedly push the “SELECT”
button for less than one second
until either “SP” (speakers) or “HS”
and “
” (headsets) appears in the
display.
2. Push either side of the up/down
switch for less than one second to
change the setting.
NOTE:
The speakers and headsets cannot be
used at the same time.
(Output)
BASS TREB
FAD
(Auto
volume)
(Intercom
volume)
Radio
SP/HS
(Treble)
frequency
(Fade )
1
2
IC AV
1
2
This mode does not appear in the display when
the headsets are selected as the output.
This mode appears in the display only when one
of the radio frequency bands is selected as the au-
dio source.
IC (Intercom volume)
RB: on/oF (Roger beep)
SP/HS
(Output)
U2C911E0.book Page 6 Tuesday, May 16, 2006 5:13 PM