Yamaha Vector RS90RX, Owner'S Manual

Page: 18 / 90

Control functions
12
The grip warmer level is initially displayed for
5 seconds, then the display switches to the
fuel meter.
Odometer and tripmeter modes
Pushing the select/reset button switches the
display between the odometer mode “ODO”
and the tripmeter mode “TRIP”.
To reset the tripmeter, push the select/reset
button for at least one second while the trip-
meter is displayed.
NOTE:
To switch the speedometer, odometer, and
tripmeter displays between kilometers and
miles, select the odometer mode “ODO”, and
then push the select/reset button for at least
10 seconds while the snowmobile is stopped.
ESU10410
High beam indicator light “ ”
The high beam indicator light comes on when
the high beams of the headlights are switched
on. (See page 16 for headlight beam switch
operation.)
ESU10481
Low coolant temperature indi-
cator light “ ”
The low coolant temperature indicator light
comes on when the coolant temperature is
low and informs the rider that the snowmobile
should be warmed up. After the engine is
started, warm it up until the indicator light
goes off.
The snowmobile can be operated normally af-
ter the indicator light goes off.
NOTE:
Operate the snowmobile at low speeds when
the low coolant temperature indicator light is
on. If the engine speed is too high, the warn-
ing light and self-diagnosis warning indicator
will flash and the two-digit code “86” will flash
1. Tachometer
2. Low coolant temperature indicator light
“ ”
3. Warning light “ ”
4. Meter display
5. Select/reset button
1. High beam indicator light “ ”
1. Low coolant temperature indicator light
“ ”
2. Warning light “ ”
3. Self-diagnosis warning indicator “ ”
4. Two-digit code “86”
U8GM10E0.book Page 12 Friday, April 27, 2007 6:43 PM