Tyros / TRS-MS01
22
Hook
Dust proof foam
(Fig.20)
(Fig.21)
(Fig.22)
(Fig.23)
(Fig.24)
[620b]
[620b]
[620a]
(Fig.19)
[620]:
Bind Head Tapping Screw-B 3.0X12 MFZN2BL (VQ074600)
26
LCD Panel Assembly
(Time required: about 14 min)
26-1
Separate the unit into the upper case assembly and the
lower case assembly. (See procedure 1)
26-2
Remove the shield upper cover. (See procedure 20-2)
26-3
Remove the two (2) screws marked [620a] to unfix the
stay bar from notch. (Fig.19)
26-4
Remove the four (4) screws marked [620b]. (Fig.19)
26-5
Remove the screw marked [C] to remove the GND2
wire on the PNR circuit board. (Fig.13)
26-6
Lay the upper case assembly right side up, unlock the
hook of LCD panel assembly and raise the LCD unit
upright. (Fig.20)
26-7
Remove the two (2) dust proof cloths. (Fig.22)
26-8
Pull out the LCD panel assembly to remove. (Fig.21)
*
After removing the LCD panel asssembly, take care
not to lose the dust proof cloth. (Fig.22)
*
After reinstalling the LCD panel assembly, follow the
procedure below and confirm that its angle can be ad-
justed.
(1) Lay the upper case assembly right side up.
(2) Unlock the hook, raise the panel forward, and con-
firm that the panel can be steadied at four notches.
(Fig.23)
(3) After raising the panel completely, confirm that it
can be laid down smoothly. (Fig.24)
