
Tyros / TRS-MS01
15
[130]
[100b]
[140]
[100a]
[100a]
Cover S
Cover L
(Fig.1)
[100]:
Bonding Screw 3.0X8 MFZN2BL (VP157800)
[130]:
Bind Head Tapping Screw-B 3.0X12 MFZN2Y (VE683000)
[140]:
Bind Head Tapping Screw-B 3.0X30 MFZN2Y (V7213700)
*
If you remove the filament tapes for disassembling, make sure to apply them on the same condition as before they are
removed.
1.
Separating the Unit into the Upper Case As-
sembly and the Lower Case Assembly
(Time required: about 9 min)
1-1
Remove the eight (8) screws marked [100a] to remove
the under cover L. (Fig.1)
1-2
Remove the screw marked [100b] and the four (4)
screws marked [130] to remove the under cover S.
(Fig.1)
1-3
Remove the two (2) screws marked [130a] to remove
the inlet lower box. (Fig.2)
1-4
Disconnect the POWER W.H [a] on the INLET circuit
board from the CN2, the VR1 W.H [b] on the
MICVRSUB circuit board from the CN7 and the
GND8 W.H [c] on the PNL circuit board from the CN7.
(Fig.4)
1-5
Disconnect the FFC2 W.H[d] and the LED W.H [e] on
the DM circuit board from the CN14 and the CN20
respectively. (Fig.3)
1-6
Remove the twenty-eight (28) screws marked [120]
and the nine (9) screws marked [130b]. (Fig.2)
1-7
Remove the six (6) screws marked [140]. (Fig.1)
1-8
Lay the unit right side up, lift the rear of the upper
case assembly and pull it diagonally downward to re-
move. (Fig.5)
*
When reinstalling the unit, tighten the four (4) screws
marked [A] before others. (Fig.2)
2.
DM Circuit Board
(Time required: about 10 min)
2-1
Separate the unit into the upper case assembly and the
lower case assembly. (See procedure 1)
2-2
If an optional hard disk unit is installed, remove the
four (4) screws marked [60] to remove the hard disk
unit with the mounting angle. (Fig.6)
2-3
Remove the seven (7) screws marked [530a]. The DM
circuit board can then be removed. (Fig.7)
3.
DJACK Circuit Board
(Time required: about 12 min)
3-1
Separate the unit into the upper case assembly and the
lower case assembly. (See procedure 1)
3-2
Remove the DM circuit board. (See procedure 2)
3-3
Remove the three (3) screws marked [530a] and the
eight (8) screws marked [540a]. The DJACK circuit
board can then be removed. (Fig.8)