PERIODIC MAINTENANCE AND ADJUSTMENT
7-31
7
5. Lift the front wheel off the ground
according to the procedure on
page 7-29.
6. Remove the axle nut and washer,
and then pull the wheel axle out.
7. Remove the wheel and the brake
shoe plate.
EAUW0550
To install the front wheel (TT-R125E)
1. Install the brake shoe plate into the
wheel.
2. Lift the wheel up between the fork
legs.
TIP
Make sure that the slot in the brake
shoe plate fits over the retainer on the
fork leg.
3. Insert the wheel axle, and then in-
stall the washer and axle nut.
4. Lower the front wheel so that it is
on the ground.
5. Connect the brake cable at the
wheel hub and then at the front
brake lever.
6. Tighten the axle nut to the speci-
fied torque.
7. Adjust the brake lever free play.
8. Push down hard on the handlebar
several times to check for proper
fork operation.
EAUW0542
To remove the front wheel
(TT-R125LW/TT-R125LWE)
WARNING
EWA10821
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the axle nut.
2. Lift the front wheel off the ground
according to the procedure in
“Supporting the motorcycle” on
page 7-29.
3. Remove the axle nut and washer.
1. Slot
2. Retainer
Tightening torque:
Axle nut:
45 Nm (4.5 m·kgf, 32 ft·lbf)
U39C81E0.book Page 31 Monday, April 26, 2010 2:43 PM
