Yamaha tmax XP500A, Service Manual

Page: 29 / 559

1 - 18
GEN
INFO
FEATURES
V-belt replacement indicator “V-BELT”
This indicator flashes every 20,000 km
(12,000 mi) when the V-belt needs to be
replaced. The electrical circuit of the indicator
can be checked according to the following pro-
cedure.
1. Turn the key to “ON” and make sure that the
engine stop switch is set to “ ”.
2. If the indicator does not come on, check the
electrical circuit. Refer to “SIGNALING
SYSTEM” in chapter 8.
To reset the V-belt replacement indicator
1. Turn the key to “ON” and make sure that the
engine stop switch is set to “ON”.
2. Disconnect the V-belt replacement reset
coupler
1
for two to ten seconds.
3. And then, connect the V-belt replacement
reset coupler, the V-belt replacement indica-
tor will come on for 1.4 seconds.
And the V-belt replacement indicator will go
off.
NOTE:
If the V-belt is replaced before the V-belt
replacement indicator comes on (i.e. before
the V-belt replacement interval has been
reached), the indicator must be reset after the
V-belt replacement for the next periodic V-belt
replacement to be indicated at the correct
time.
Self-diagnosis device
Refer to “ANTI-LOCK BRAKE SYSTEM
(XP500A)” in chapter 4 “FUEL INJECTION
SYSTEM” in chapter 7 and “IMMOBILIZER
SYSTEM” in chapter 8.
Clock mode
To set the clock:
1. Push the “SELECT” button and “RESET”
button together for at least two seconds.
2. When the hour digits start flashing, push
the “RESET” button to set the hours.
3. Push the “SELECT” button, and the minute
digits will start flashing.
4. Push the “RESET” button to set the min-
utes.
5. Push the “SELECT” button and then
release it to start the clock.