Yamaha TEO'S XN125, Owner'S Manual

Page: 20 / 90

3
3-4
1. Speedometer
2. Odometer
3. “TRIP” button 1. Tripmeter
INSTRUMENT AND CONTROL FUNCTIONS
EAU01586
Speedometer unit
The speedometer unit is equipped with
a speedometer, an odometer and a
tripmeter. The speedometer shows
riding speed. The odometer shows the
total distance traveled. The tripmeter
shows the distance traveled since it
was last set to zero.
Pushing the “TRIP” button switches the
display between the odometer mode
“TOTAL” and the tripmeter mode
“TRIP”. To reset the tripmeter, enter the
“TRIP” mode, and then hold down the
“TRIP” button for at least two seconds.
The tripmeter can be used together with
the fuel gauge to estimate the distance
that can be traveled with a full tank of
fuel. This information will enable you
to plan future fuel stops.
TOTAL
1
2
3
ZAUM0008
TOTAL
1
ZAUM0009
EAUM0040
Setting the odometer/tripmeter
reading mode
The odometer and tripmeter can be set to
count in either miles or kilometers
according to the following procedure.
1. Turn the key to “ON” while pressing
the “TRIP” button.
2. Release the “TRIP” button when the
display comes on.
3. The current mode appears in the
display: “CONT” (continental) for the
kilometer mode and “EnGL” (English)
for the mile mode.
4. Press the “TRIP” button to switch the
mode.
5. Press the “TRIP” button for two se-
conds to confirm the setting.
NOTE:
• The odometer/tripmeter reading mode
can be changed any number of times
while the odometer reading is below
10, but it cannot be changed anymore
after the reading has reached 10.
• Switching between the mile and the
kilometer mode does not change or
convert the current odometer/tripmeter
reading.