Perio
d
ic maintenance an
d
a
d
justment
7-12
7
TIP
Make sure that the O-rings are properly
seated.
7. Install the oil filter element cover
and tighten the bolts.
8. Install the engine oil drain bolt with
a new gasket and tighten the bolt.
9. Refill the crankcase with the spec-
ified amount of engine oil, and
then install the oil filler cap.
NOTICE
ECA10441
After chan
g
in
g
the en
g
ine oil,
b
e
sure to check the oil pressure as
d
e-
scri
b
e
d
b
elow.
10. Remove the bleed bolt, start the
engine and keep it idling until oil
flows out, then install the bleed
bolt.
TIP
If no oil comes out after one to two
minutes, stop the engine. Consult your
Yamaha dealer for inspection before
riding the vehicle again.
11. After checking the oil pressure,
tighten the bleed bolt.
12. Start the engine and let it idle for
several minutes. Check for oil
leakage.
13. Turn the engine off, and check the
oil level one last time.
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
EAUB1282
Replacin
g
the air filter ele-
ment an
d
cleanin
g
the check
hoses
The air filter element should be re-
placed at the intervals specified in the
periodic maintenance and lubrication
chart. Replace the air filter element
more frequently if you are riding in un-
usually wet or dusty areas. In addition,
the air filter check hoses must be fre-
quently checked and cleaned if neces-
sary.
To replace the air filter element
1. Remove the air filter case cover by
removing the screws.
Ti
g
htenin
g
torque:
Oil filter element cover bolt:
10 N·m (1.0 kgf·m, 7.2 lb·ft)
Ti
g
htenin
g
torque:
Engine oil drain bolt:
20 N·m (2.0 kgf·m, 14 lb·ft)
Ti
g
htenin
g
torque:
Bleed bolt:
7 N·m (0.7 kgf·m, 5.2 lb·ft)
1. Air filter case cover
2. Air filter element
2
1
ZAUV0250
ZAUV0250
ZAUV0250
UB6FE0E0.book Page 12 Friday, August 11, 2017 3:37 PM