Battery Use
CAUTION
• Your SEASCOOTER
™
is supplied with a battery that
needs to be treated carefully as it will release
potentially explosive gases during its normal cycle of
use (off-gassing). Failure to do so can result in an
explosion occurring. Please read the entire manual
thoroughly and follow all instructions.
• Always remove the battery from your SEASCOOTER
™
when it is not in use and store separately in a well
ventilated area where it is out of the reach of children
and away from heat and ignition sources.
• Do not attach the battery in your SEASCOOTER
™
until
prior to using it.
• Before removing/placing the battery, open the nose
cone and allow two minutes for any explosive gases to
dissipate.
• Do not use/store/charge the battery in temperatures
above 40ºC (104ºF) as excessive off-gassing may
occur. Keep the battery and SEASCOOTER
™
in the
shade when not in use.
• Always ensure the unit is dried thoroughly before
opening the Nose Cone.
• Only use the charger supplied with the SEASCOOTER
™
.
Battery Use
13
12
To Remove the 275L Nose Cone and charge the Battery
Pod, User MUST follow these instructions to avoid any
injury.
1. ALWAYS ensure that the Master Switch is in OFF position.
2. ALWAYS ensure that the 275L is out of the water, dry and
placed in a dry area.
3. Pull the four Latches down and remove the nose cone by
using the left and right Latches to break the seal if
necessary (see Fig. 11 and Fig. 12) and jump to Step 9.
4. If the nose-cone cannot be opened by pressing the
latches, replace the Retractable rubber handle on the
SEASCOOTER™ 275L. (see Fig. 13)
5. Release the Vent plug on top of the Nose Cone.
6. Pull the rubber ring through the retractable rubber handle
and attach both ends around the top and bottom latch
hinge as shown in Fig. 13.
7. Screw the pump nozzle to the vent chamber and pump air
in until the Nose Cone pops off
(see Fig. 14).
IMPORTANT
: ALWAYS attach the Rubber Ring before
using the pump. The Nose Cone can pop off and cause
injury if the Rubber Ring is not attached and tighly
secured.
8. Remove the Rubber Ring and remove the Nose Cone
(see Fig. 15).
9. Allow two minutes for any gases to dissipate.
10. Take out the Battery Pod from the unit.
11. Connect the Battery Pod to the Charging Base.
(see Fig. 16)
12. Plug the Charging Base into the mains, and turn on the
supply.
13. Charging will take around 12-14 hours for a fully
discharged battery. When the Battery Pod is charging, the
RED LED light on the Battery Pod remains flashing.
When the battery is fully charged, the GREEN LED
flashes. (see Fig. 16)
14. Unplug the Charging Base from the electrical socket/plug.
15. Allow battery to stand for 30 minutes before using it.
16. Unplug the Battery Pod from the Charging Base.
17. When ready to use, reconnect to the unit in the correct
position. (see Fig. 17)
18. MAKE SURE the O-ring Seals and sealing surfaces are
clean and fully lubricated
with the supplied grease
EVERYTIME (you can also
buy this at your local
hardware store) before
replacing the Nose Cone.
(see Fig. 18)
19. Ensure the Vent O Ring is
fitted correctly into the
groove and fully lubricated
with the supplied grease. (see
Fig. 18)
20. MAKE SURE to screw in the
Vent Plug to seal the vent.
21. Replace the Nose Cone and
close the Latches.
WARNING
BATTERY SAFETY
CAUTION
BATTERY SAFETY
• Must remove and store the battery separately from the unit when
not in use!
• Must re-charge the battery after use
WITHIN 24 HOURS.
• Must re-charge the battery at least
EVERY THREE MONTHS
when not in use.
User Manual must be read and understood before use.
Please read and follow the
Battery Safety Instruction.
Incorrect battery maintenance may reduce the battery life and
influence its function.
• Our lead-acid battery is designed specifically for
each Seascooter. For your own safety, NEVER
REPLACE THE ORIGINAL SEASCOOTER BATTERY
WITH AN AFTERMARKET BATTERY.
• Only Seascooter with original battery will be warranted by our
service center.
• Always contact official dealer/service center to service the
Seascooter. Any changes made by consumer/unauthorized
parties will void the warranty of the Seascooter.
• Visit our website to purchase replacement battery for Seascooter.
• Visit our website to find an original equipment battery distributor in
your region.
www.seascooter.net
RE-CHARGE THE BATTERY
3
3
AT LEAST
MONTHS
EVERY
MONTHS
