51
Basics Section
Quick Guide
Refer
ence
Appendix
Using as a Master Keyboard
Using Zones —
Creating a Layer/
Split with an external
tone generator
In the example below, we’ll set up three Zones as
shown below. We’ll program a split at the note C3. In
the lower range (B2 and lower), a bass voice and
cymbal voice will sound. In the upper range (C3 and
above), we’ll layer piano and vibraphone voices —
played from an external MIDI tone generator. Using
this sophisticated setup, you can easily sound like an
entire jazz group, with just your two hands.
In the example instructions here, we’ll use the Voice
mode for the Master.
1
Select a Voice in the
Master Play mode.
Set the Mode to Voice, then select the PRE1 bank and
voice 123.
2
Set the Zone Switch to on.
3
Enter the Master Edit mode.
Common Edit and Individual zone Edit
To edit parameters common to all of the zones,
press the [DRUM KITS] button (which serves as a
“COMMON” button here).
To edit parameters of the individual zones, select the
desired zone with the corresponding NUMBER
button, [1] - [4].
n
This operation is available only when the Zone
Switch is set to on in the [F2] (MEMORY) display
in the Master Play mode.
4
Call up the display for
Zone editing.
Press any of the buttons.
Zone 2
(Piano)
Zone 1
(Bass + Cymbal)
Zone 3
(Vibraphone)
C3
Internal tone
generator
External tone
generator
DEC/NO
INC/YES
DEC/NO
INC/YES
EXIT
ENTER
EXECUTE
JOB
EDIT
COMPARE
STORE
DRUM KITS
FAVORITES
1
2
3
4
ELEMENT / PERF.PART / ZONE
1
2
3
4
ELEMENT / PERF.PART / ZONE
Summary of Contents for S90
Page 136: ...136 MEMO ...