Yamaha RX-V775, Owner'S Manual

Page: 35 / 139

PREPARATIONS
➤
Connecting the power cable
En
35
Connecting a device compatible with the trigger function
The trigger function can control an external device in conjunction with operating the
unit (such as powering on/off and input selection). If you have a Yamaha subwoofer that
supports a system connection or a device with a trigger input jack, you can use the
trigger function by connecting the external device to the TRIGGER OUT jack.
• You can configure the trigger function settings in “Trigger Output” (p.101) in the “Setup” menu.
After all the connections are complete, plug in the power cable.
AUDIO 1 AUDIO 2
OPTICAL
OPTICAL
COAXIAL
VIDEO
AV4
AV 3
AV2
AV 1
(TV)
P
B
Y
P
R
1 2
ARC
ANTENNA
AM
AV 5
VIDEO
AV 6 AV OUT
NETWORK DC OUT
TRIGGER OUT
REMOTE
5V 0.5A
(NET)
12V
IN
OUT
0.1A
COMPONENT VIDEO
HDMI OUT
(RADIO)
TRIGGER OUT
12V 0.1A
The unit (rear)
TRIGGER OUT jack
System
connection
input
Yamaha subwoofer that
supports a system connection
8 Connecting the power cable
Before connecting the power cable (General model only)
Set the switch position of VOLTAGE SELECTOR according to your local voltage.
Voltages are AC 110–120/220–240 V, 50/60 Hz.
• Make sure you set VOLTAGE SELECTOR of the unit BEFORE plugging the power cable into an AC
wall outlet. Improper setting of VOLTAGE SELECTOR may cause damage to the unit and create a
potential fire hazard.
UND
S INGLE
S URROUND BACK/BI-AMP
ZONE2/F.PRE S ENCE
EXTRA S P
220V-
240V
110V-
120V
VOLTAGE SELECTOR
The unit (rear)
VOLTAGE SELECTOR
5
CENTER S URROUND
S INGLE
S URROUND BACK/BI-AMP
S PEAKER S
ZONE2/F.PRE S ENCE
EXTRA S P
To an AC wall outlet
The unit (rear)
1 2 3 4 5 6 7
Other connections
8
Power cable connection
9 10