Yamaha RX-V367, Service Manual

Page: 23 / 105

C D D A U p g r a d e r
Display
X X X X X X X X X X U p d a t e S u c c e s s
P l e a s e . . .
P o w e r o f f ! !
Writing is started Writing is completed
X X X X X X
: Received data
"INFO" key
23
RX-V367/HTR-3063
RX-V367/HTR-3063
Fig. 2
●
Operation Procedures
1. While pressing the “INFO” key of this unit, connect the power cable of this unit to the AC outlet. (Fig. 2)
The FIRMWARE UPDATE mode is activated and “CDDA Upgrader” is displayed. (Fig. 2)
Fig. 3
2. Eject the disc tray of the DVD/CD player, load the firmware CD on it and press the “PLAY” key. Writing of the
firmware starts automatically. (Fig. 3)
3. When writing of the firmware is completed, “Update Success”, “Please...” and “Power off!!” are displayed
repeatedly. (Fig. 3)
*
When the version of the firmware to be written is the same as the one existing in this unit, “Same Version”,
“Please...” and “Power off!!” are displayed repeatedly. (Updating is not necessary.)
If the display remains unchanged for more than 10 seconds after starting the firmware CD play procedure,
perform the firmware CD play procedure again from the beginning.
If “FILE CORRUPTED” is displayed after “Address:XXXXXX”, make sure that the written data is not corrupted
and perform Steps 1 to 7 of “Operation Procedures” again.
If “Upgrade Failed” is displayed, perform “operation procedures” again from the beginning.
4. Press the “ ” (Power) key of this unit to turn off the power.
5. Eject the disc tray of the DVD/CD player and unload the firmware CD from it.
6. Start up the self-diagnostic function and check that the firmware version and checksum are the same as written
ones. (See “Confirmation of firmware version and checksum”)