En
29
Connection diagram
Refer to the following diagram and connect the speakers to the unit.
Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit and
the speaker, and the other is for the positive (+) terminal. If the wires are colored to prevent
confusion, connect the black wire to the negative and the other wire to the positive terminal.
1
Remove approximately 10 mm (3/8”) of insulation from the ends of the speaker cable, and
twist the bare wires of the cable firmly together.
2
Loosen the speaker terminal.
3
Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the
terminal.
4
Tighten the terminal.
Using a banana plug
(China model only)
1
Tighten the speaker terminal.
2
Insert a banana plug into the end of the terminal.
Connecting the subwoofer (with built-in amplifier)
Use an audio pin cable to connect the subwoofer.
1
2
ZONE OUT/PRE OUT
ZONE 2/
F.PRESENCE
ZONE 3/
R.PRESENCE
SPEAKERS
CENTER
FRONT
SURROUND BACK
SURROUND
R.PRESENCE
R
L
R
R
R
L
L
R
L
L
R
L
ZONE 2/ZONE 3/F.PRESENCE
ZONE 2/ZONE 3/BI-AMP
PRE OUT
(REAR)
SUBWOOFER
CENTER
FRONT
FRONT
SURROUND
SUR. BACK
(FRONT)
EXTRA SP2
F.PRESENCE
EXTRA SP1
1
2
3
4
5
9
9
T
6
7
Y
E
R
The unit
(rear)
FR
ONT
+
1
1
2
2
4
4
3
3
+ (red)
– (black)
FR
ONT
+
1
1
2
2
Banana plug
(FR
ONT)
(REAR)
SUBW
OOFER
PRE OUT
CENTER
SUR.
BACK
SURR
UND
1
2
SURR
OUND B
ACK
L
Audio pin cable
