En
157
Switching the video signal type (TV FORMAT)
Switch the video signal type of the unit so that it matches to the format of your TV.
Settings
NTSC, PAL
Removing the limitation on HDMI video output
(MONITOR CHECK)
The unit automatically detects resolutions supported by a TV connected to the HDMI OUT jack.
Disable the monitor check function if you want to specify a resolution in “Resolution” (p.140)
when the unit cannot detect the TV’s resolution or when you want to specify a different
resolution than the detected resolution.
Settings
Y
Reset to “YES” if the unit becomes inoperable because video from the unit cannot be displayed on the TV after
“MONITOR CHECK” has been set to “SKIP”.
Selecting the HDMI 4K signal format (4K MODE)
Selects the format of signals input/output at the unit when HDMI 4K compatible TV and
playback device are connected to the unit.
Settings
Format
Y
When “MODE 1” is selected, use a Premium High Speed HDMI Cable or Premium High Speed Cable with Ethernet.
YES
Enables the monitor check function. (Outputs video signals with a resolution
supported by the TV only.)
SKIP
Disables the monitor check function. (Outputs video signals with a specified
resolution regardless of compatibility with the TV.)
NTSC
TV FORMAT
YES
MONITOR CHECK
MODE 1
Inputs/outputs 4K signals shown in the table below.
Depending on the connected device or HDMI cables, video may not be displayed
correctly. In this case, select “MODE 2”.
MODE 2
Inputs/outputs 4K signals shown in the table below.
MODE 1
MODE 2
8 bit
10 bit
12 bit
8 bit
10 bit
12 bit
4K/60, 50 Hz
RGB 4:4:4
,
-
-
YCbCr 4:4:4
,
-
-
YCbCr 4:2:2
,
-
YCbCr 4:2:0
,
,
-
4K/30, 25, 24 Hz
RGB 4:4:4
,
,
-
YCbCr 4:4:4
,
,
-
YCbCr 4:2:2
,
,
MODE 1
4K MODE
