En
104
Selecting the remote control ID (REMOTE ID)
Select the remote control ID of the main unit so that it matches to the ID of the remote
control (default: ID1). When using multiple Yamaha AV receivers, you can set each
remote control with a unique remote control ID for its corresponding receiver.
Settings
ID1 (default), ID2
■
Changing the remote control ID of the remote control
Perform each of the following steps within 1 minute. Otherwise, the setting will be
automatically canceled.
1
Press CODE SET on the remote control using a pointed object such as the tip of a
ballpoint pen.
2
Press SOURCE/RECEIVER.
3
Use the numeric keys to enter “5019” (ID1) or “5020” (ID2).
Once the remote control ID is registered successfully, SOURCE/RECEIVER blinks twice.
If it blinks 6 times, registration failed. Repeat from step 1.
• The registered remote control codes (p.106) are not cleared even if you change the remote control ID.
Switching the video signal type (TV FORMAT)
Switch the video signal type of this unit so that it matches to the format of your TV.
Settings
NTSC, PAL (default)
Removing the limitation on HDMI video output
(MON.CHK)
This unit automatically detects resolutions supported by a TV connected to the HDMI
OUT jacks.
If you want to select a resolution in “Resolution” (p.95) regardless of the detection
results or if this unit does not detect it correctly, disable the monitor check function.
Settings
• In case this unit becomes inoperable because videos from this unit cannot be displayed on the TV after
“MON.CHK” is set to “SKIP”, reset the setting to “YES.
Restoring the default settings (INIT)
Restores the default settings for the selected item.
Choices
REMOTEID-ID1
YES (default)
Enables the monitor check function. (Outputs video signals with a
resolution supported by the TV only.)
SKIP
Disables the monitor check function. (Outputs video signals with a
specified resolution regardless of compatibility with the TV.)
VIDEO
Restores the default settings for video configurations.
ALL
Restores the default settings for this unit.
CANCEL
Does not perform an initialization.
TVFORMAT-PAL
MON.CHK-YES
INIT-CANCEL
