CONNECTIONS
Setting up the speaker parameters automatically (YPAO)
En
49
2
Select the desired menu item (or enable a
function) using
i
Cursor
B
/
C
/
D
/
E
and
i
ENTER
.
3
Press
i
RETURN
to finish the Result menu.
■
Reloading automatic setup
parameters
If you are not satisfied with the fine-adjustment of setup
parameters with Manual Setup, the result of automatic
setup saved on this unit can be reloaded. Select “Setup
Reload” in the Result menu.
■
When an error message is
displayed during measurement
) for instructions on
resolving the problem and measure acoustics again.
Check the error code displayed and use YPAO to
measure acoustics again as described below.
When “E-1,” “E-2,” “E-3,” “E-4,” “E-6” or “E-11”
is displayed:
1
Press
i
ENTER
.
2
Press
i
Cursor
E
to select “EXIT.”
3
Press
i
ENTER
to terminate YPAO, and
switch the unit to standby mode.
4
Check that the speakers are properly
connected.
5
Turn on the unit and use YPAO again.
RETURN
ENTER
RETURN
ENTER
SOURCE
RECEIVER
AV
AUDIO
4
3
1
2
7
5
6
V-AUX
4
3
1
2
USB
MULTI
NET
PHONO
TUNER
DOCK
SIRIUS
[ A ]
i
Wiring
Displays the speakers connected to this
unit and the polarity of each connected
speaker.
•
“Normal” is displayed when the
polarity of the connected speaker is
normal.
•
“Reverse” is displayed when the
polarity of the connected speaker is
opposite.
Size
Displays the size of the connected
speakers and the bass cross over
frequency (“Bass Crossover”).
•
“Large” is displayed when the
connected speaker has the ability to
reproduce the low-frequency signals
effectively.
•
“Small” is displayed when the
connected speaker does not have the
ability to reproduce the low-frequency
signals effectively.
Distance
Displays the distance from the listening
position to speakers. The unit for distance
can be switched between “ft” (feet) and
“m” (meter) by pressing
i
Cursor
D
/
E
.
Level
Displays the result of the adjustment of
each connected speaker output level.
Angle
Displays the angles of the front speakers,
surround speakers, front presence
speakers and rear presence speakers at the
measured point.
Setup Reload
J
1
Clears the fine-adjustment with Manual
Setup and reloads the result of automatic
setup. For details, refer to “Reloading
The result of automatic setup can be fine-tuned
manually by “Manual Setup.” Refer to “Manual
speaker setup” (
) for details.
NOTE
When automatic setup parameters are reloaded,
manually configured settings are cleared. To avoid
clearing manually configured settings by reloading
automatic setup parameters, see “Prohibiting setting
changes” (
Continues to the
next page
J
1 :
This item is displayed after the fine-adjustment is performed with
“Manual Setup.” Use this item to return the settings to the result
of automatic setup.
