Periodic maintenance and adjustment
91
6.
Recheck alignment and deflection. If
necessary, repeat steps 3 to 5 until the
proper adjustment is achieved.
7.
Lower the snowmobile to the ground.
8.
Tighten the rear axle nut.
Slide runners
Check the slide runners for wear and dam-
age.
If the slide runners reach the wear limit, they
should be replaced.
RST9N
RST1NTF / RST1NTFY
NOTICE
ECS00351
Ride on fresh snow frequently. Operating
on ice or hard-packed snow will rapidly
wear the slide runners.
ESU12199
Lubrication
Lubricate the following points with the speci-
fied grease.
WARNING
EWS00512
Do not grease the throttle cable because it
could become frozen, which could cause
loss of control. Apply a dab of grease onto
the cable end only.
TIP
For parts equipped with a grease nipple, use
a grease gun.
Rear axle nut tightening torque:
75 N·m (7.5 kgf·m, 55 lb·ft)
1. Slide runner
2. Wear limit height
1. Slide runner
2. Wear limit height
Slide runner wear limit height:
10.5 mm (0.41 in)
1
2
1
2
Lubricants:
Brake lever:
Silicone grease
Other lubrication points:
Low-temperature grease
1. Lubrication point
1
U8JV72E0.book Page 91 Thursday, May 18, 2017 1:47 PM
Downloaded from