28
After 15 seconds the microphone will beep 5 times, and will continue beeping
every 30 seconds to indicate that it is out of range.
Move the Countryman Adapter closer to the Base Station and the connection
will automatically be re-established to its original state, and the beeping will
cease. If not, the Countryman Adapter will continue beeping until it turns off in
about 15 minutes.
Pairing Wireless Microphones to Base Station
Pairing creates a link between the HD Wireless Microphone and the Base
Station, with a unique electronic serial number. When the microphone and
Base Station have been previously paired, the mic will automatically try to
connect to the same Base Station whenever it is lifted from the Charger Base.
Note:
Microphones in new systems must be paired to the Base Station with
each microphone assigned to a unique channel on the Base Station.
Remember, microphones are always muted (flashing RED LED) when they are
removed from the Charger Base and the Mute button needs to be pressed to
make it “live” (flashing GREEN LED).
A microphone that is not paired will be indicated by a cycling RED-GREEN
LED pattern. A Base Station channel that is not paired to a microphone will
not show any activity on the channel LED (make sure unit is first powered on
by observing GREEN backlit front panel display).
When channels are paired, both microphone and channel LEDs will flash RED
as microphones are removed from the Charger Base and flash GREEN when
un-muted. Remember that only one microphone can be paired to any single
Base Station channel.
To pair an individual microphone to the Base Station:
1. Turn the microphone OFF (no LED activity). If the microphone is ON, press
and hold the Mute button for 10 seconds until the LED turns solid RED
then release the button to turn the unit off. (do not release the button when
you hear two beeps).
2. Place the microphone unit into pairing mode by holding the Mute button
down for seven seconds. The LED will turn solid RED. Release the Mute
button. The microphone is now in pairing mode.
3. Within one minute, push and hold the button for the desired channel on the
Base Station for seven seconds until the LED turns solid red then release.
The LED for that channel will be solid red until pairing starts, as indicated
by a quick GREEN flash, then switching to flashing RED on both the
microphone and the Base Station (muted audio). Pairing is now complete.
