26
To use the HD Universal Wireless Adapter:
1. Remove the Microphone Adapter from the Charger Base.
The adapter turns on and mutes automatically when removed from Charger
Base (flashing RED LED). The XLR Microphone Adapter is attached to a
standard dynamic microphone to convert it from a wired microphone to a
wireless microphone (see following figure).
Note:
The Adapter does not provide phantom power or bias current so it
cannot be used with condenser or electret microphones.
2. With the microphone attached, un-mute the Adapter by pressing and
releasing the Mute button (confirm by a flashing GREEN LED).
Note:
If the microphone has an on-board mute switch, this switch must
also be un-muted prior to use.
3. To turn the Adapter off, return the microphone unit to the Charger Base or
press and hold the Mute button for ~10 seconds until the LED turns solid
RED then release button.
Important
: Always remove the microphone from the Adapter by pressing
the latch switch and separating the parts before returning the Adapter to
the Charger Base.
If the Adapter is moved too far from the Base Station (~300 feet or 90 meters)
the connection will be dropped (LED flashes all colors) and the audio will mute.
After 15 seconds the microphone will beep 5 times, and will continue beeping
every 30 seconds to indicate that it is out of range.
Move the XLR Adapter closer to the Base Station and the connection will
automatically be re-established to its original state, and the beeping will cease.
If not, the XLR Adapter will continue beeping until it turns off in about 15
minutes.
