Yamaha QY100 Data Filer, Data List

Page: 49 / 72

M I D I D a t a F o r m a t
49
(3-6-3) PARAMETER CHANGE
(3-6-3-1) MIDI MASTER TUNING
F0H 43H 1nH 27H 30H 00H 00H mmH llH ccH F7H
Modifies the MASTER TUNE value.
The values of mm and ll are used as the MIDI Master Tuning.
(n and cc values are ignored.)
T = M*200/256-100
Where T : actual tuning value (-99 — +99)
M : a one-byte value with MSB of ”mm“ bits 0-3, and LSB of ”ll“ bits 0-3.
(3-6-3-2) XG SYSTEM ON
11110000 F0 Exclusive status
01000011 43 YAMAHA ID
0001nnnn 1n device Number
01001100 4C Model ID
0aaaaaaa 00 Address High
0aaaaaaa 00 Address Mid
0aaaaaaa 7E Address Low
00000000 00 Data
11110111 F7 End of Exclusive
When On is received, the SYSTEM MODE will be changed to XG.
Since approximately 50 ms is required in order to execute this message, an appropriate interval must be
allowed before the next message.
Controllers will be reset, and all Multi Part and Effect data of the attached table, together with the values
of all data of All System that are noted as (XG), will be reset to the Default values.
(3-6-3-3) XG PARAMETER CHANGE
11110000 F0 Exclusive status
01000011 43 YAMAHA ID
0001nnnn 1n device Number
01001100 4C Model ID
0aaaaaaa aaaaaaa Address High
0aaaaaaa aaaaaaa Address Mid
0aaaaaaa aaaaaaa Address Low
0ddddddd ddddddd Data
| |
11110111 F7 End of Exclusive
For parameters with a Data Size of 2 or 4, the corresponding amount of data will be transmitted.
For Addresses and Byte Counts, refer to the attached tables.
The following four types are transmitted and received. ( Transmitted only if a Parameter Change Request
is received.)
System Data
Multi Effect Data
(ignored in Voice Mode)
Multi Part Data (ignored in Voice Mode)
Drums Setup Data
(3-6-4) BULK DUMP
(3-6-4-1) XG BULK DUMP
11110000 F0 Exclusive status
01000011 43 YAMAHA ID
0000nnnn 0n device Number
01001100 4C Model ID
0bbbbbbb bbbbbbb ByteCount
0bbbbbbb bbbbbbb ByteCount
0aaaaaaa aaaaaaa Address High
0aaaaaaa aaaaaaa Address Mid
0aaaaaaa aaaaaaa Address Low